Step 1: Connect the equipment
- Connect the Serial 0/0/0 interface of Router 1 to the Serial 0/0/0 interface of Router 2 using a serial cable.
- Connect the Fa0/0 interface of Router 1 to the Fa0/1 port on Switch 1 using a straight-through cable.
- Connect Host 1 to the Fa0/3 port on Switch 1 using a straight-through cable.
- Connect Host 2 to the Fa0/2 port on Switch 1 using a straight-through cable.
- Connect the Discovery Server to the Fa0/0 interface of Router 2 using a crossover cable.
Step 2: Perform basic configuration on Router 1
Step 3: Perform basic configuration on Router 2
Step 4: Perform basic configuration on Switch 1
Step 5: Configure the hosts with the proper IP address, subnet mask, and default gateway
a. Configure each host with the proper IP address, subnet mask, and default gateway.
1) Host 1 should be assigned 192.168.1.5 /24 and the default gateway of 192.168.1.1.
2) Host 2 should be assigned 192.168.1.6 /24 and the default gateway of 192.168.1.1.
3) The server should be assigned 172.17.1.1 and a default gateway of 172.17.0.1.
b. Each host should be able to ping the other hosts
Step 6: Configure and apply ACLs
ACLs will be configured to control what services Hosts 1 and 2 can access from the server.
Step 7: Reflection
- What is an advantage of using the logging option on an ACL versus the information provided by the show access-lists command? Jawaban : The logging option gives you more detailed information about what the access list is doing.
- What is a major concern of enabling the logging feature of an access control list?Jawaban : The amount of router resources that will be used to display the console messages.
- Would you normally log more than one line? Why or why not? Jawaban : the ACL and what you are trying to do with it. If there are two lines that you think are not working exactly right, you would log those two lines.
0 comments:
Post a Comment